IPhone 6 Plus Battery Replacement

Error

Difficulty

Hard

Steps

18

Time Required

2 hours

Introduction

This guide is for a battery replacement for the iPhone 6 Plus

Tools Required

Phillips #000 Screwdriver

P2 Pentalobe Screwdriver

Spudgers

Tweezers

iPhone opening tool

Nylon String

Parts

Error

Battery for iPhone 6 Plus

S$20.00

Buy

You can contact us to book an appointment should you find the guide too difficult to follow

Precautions

• Work on a clear and open surface • Careful when unscrewing as most of the screws are extremely small, have a small box ready with you • Take note and keep track of each screw during disassembling and assembling

Step 1
Error

Power off your iPhone before beginning disassembly. Remove the two 3.6 mm P2 Pentalobe screws next to the Lightning connector.

Step 2
Error
Error
Error

Close the handle on the opening tool, opening the suction-cup jaws. Place you iPhone in between the suction cups, against the plastic depth gauge. Open the handles to close the jaws of the opening tool. Center the suction cups and press them firmly onto the top and bottom of the iPhone. Hold onto your iPhone securely and close the handle of the opening tool to separate the suction cups, pulling the front panel up from the rear case. Peel the two suction cups off your iPhone.

Step 3
Error

Pull the home button end of the front panel assembly away from the rear case, using the top of the phone as a hinge.

Step 4
Error

Remove the following Phillips screws from the battery connector bracket: One 2.3 mm screw (Red Circle) One 3.1 mm screw (Yellow Circle)

Step 5
Error

Remove the metal battery connector bracket from the iPhone.

Step 6
Error

Use the spudger to gently pry the battery connector up from its socket on the logic board.

Step 7
Error

Remove the following Phillips screws securing the front panel assembly cable bracket: Three 1.2 mm screws (Yellow Circle) One 1.5 mm screw (Red Circle) One 2.9 mm screw (Orange Circle)

Step 8
Error

Remove the front panel assembly cable bracket from the logic board.

Step 9
Error
Error
Error
Error

Use a spudger or a fingernail to disconnect the three front panel assembly cables in below order: 1. Front-facing camera and earpiece speaker connector 2. Disconnect the home button cable connector. 3. Display data cable connector. Remove the front panel assembly from the rear case.

Step 10
Remove Battery
Error
Error
Error
Error

Note: Battery is glued to the chassis of iphone Slightly pry up the top of the battery Insert nylon string between battery and chassis Slowly remove the adhesive Insert the new battery, make sure that battery connector is aligned to socket

Step 11
Error
Error
Error
Error

Connect back the three front panel assembly cables in below order: 1. Display data cable connector. 2. Disconnect the home button cable connector. 3. Front-facing camera and earpiece speaker connector.

Step 12
Error

Place back the front panel assembly cable bracket onto the logic board.

Step 13
Error

Secure back the following Phillips screws to secure the front panel assembly cable bracket: Three 1.2 mm screws (Yellow Circle) One 1.5 mm screw (Red Circle) One 2.9 mm screw (Orange Circle)

Step 14
Error

Connect back the battery connector onto its socket on the logic board.

Step 15
Error

Place back the metal battery connector bracket

Step 16
Error

Secure back following Phillips screws: One 2.3 mm screw (Red Circle) One 3.1 mm screw (Yellow Circle)

Step 17
Error

Close back the iphone screen

Step 18
Error

Secure back the two 3.6 mm P2 Pentalobe screws next to the Lightning connector.


Troubleshooting