IPhone 6 Battery Replacement
Introduction
This guide is for a battery replacement for the iPhone 6
Tools Required
• Phillips #000 Screwdriver
• P2 Pentalobe Screwdriver
• Spudgers
• Tweezers
• iPhone opening tool
• Nylon String
Parts
Battery for iPhone 6
S$18.80
Buy
You can contact us to book an appointment should you find the guide too difficult to follow
Precautions
• Work on a clear and open surface • Careful when unscrewing as most of the screws are extremely small, have a small box ready with you • Take note and keep track of each screw during disassembling and assembling
Step 1
Power off your iPhone before beginning disassembly. Remove the two 3.6 mm-long P2 Pentalobe screws next to the Lightning connector.
Step 2
Close the handle on the opening tool, opening the suction-cup jaws. Place you iPhone in between the suction cups, against the plastic depth gauge. Open the handles to close the jaws of the opening tool. Center the suction cups and press them firmly onto the top and bottom of the iPhone. Hold onto your iPhone securely and close the handle of the opening tool to separate the suction cups, pulling the front panel up from the rear case. Peel the two suction cups off your iPhone.
Step 3
Pull the home button end of the front panel assembly away from the rear case, using the top of the phone as a hinge.
Step 4
Remove the following Phillips screws from the battery connector bracket: One 2.2 mm screw (Orange Circle) One 3.2 mm screw (Red Circle)
Step 5
Remove the metal battery connector bracket from the iPhone.
Step 6
Disconnect the battery connector
Step 7
Remove the following five Phillips screws securing the front panel assembly cable bracket: Three 1.2 mm screws (Orange Circle) One 1.7 mm screw (Yellow Circle) One 3.1 mm screw (Red Circle)
Step 8
Remove the front panel assembly cable bracket from the logic board.
Step 9
Use a spudger or a fingernail to disconnect the following cables: Front-facing camera and sensor cable connector. Display data cable connector. Digitizer cable connector.
Step 10
Remove the front panel assembly from the rear case.
Step 11
Note: Battery is glued to the chassis of iphone Slightly pry up the top of the battery Insert nylon string between battery and chassis Slowly remove the adhesive
Step 12
Paste battery adhesive on new battery
Remove the small blue tab
Step 13
Paste the black portion of the tape to the bottom front of the battery
Step 14
Peel away the plastic sheet
Step 15
Paste the adhesive to the back of the battery
Step 16
Peel away the plastic sheet Paste the new battery on the chassis Make sure battery connector is aligned to the socket
Step 17
Place back the front display assembly Insert back the following cables: Digitizer cable connector. Display data cable connector. Front-facing camera and sensor cable connector.
Step 18
Place back the metal bracket Secure the following five Phillips screws: Three 1.2 mm screws (Orange Circle) One 1.7 mm screw (Yellow Circle) One 3.1 mm screw (Red Circle)
Step 19
Connect back the battery connector
Step 20
Place back the metal bracket Secure the following Phillips screws: One 2.2 mm screw (Orange Circle) One 3.2 mm screw (Red Circle)
Step 21
Close back the phone
Step 22
Secure back the two 3.6 mm-long P2 Pentalobe screws next to the Lightning connector.